CATCO Parts & Service

The Measurement Guides below, will guide you in measuring your application correctly to ensure proper fit and performance each and every time.

IT'S EASY TO GET IT RIGHT THE FIRST TIME...

To measure cars and trucks properly...Place two safety stands under the differential housing tubes to support vehicle.

Step #1. Pick the Measurement Guide that looks like your application...MEASURE EXACTLY as it shows.

Step #2. You will need a tape measure and a good 6" ruler. Remember to always measure your application with the rear suspension as it would be sitting on the ground. If measuring 4X4 trucks you must have both the front and rear suspension as it would be sitting on the ground.

Step #3. Each Measurement Guide will give you spaces to fill in and choices for the different possibilities...Please remember we will need all the questions answered for the Guide you are using.

Measurement Guide  #1 & #2  - Street and Race applications

Measurement Guide  #3           - Ford rear drive shafts with and without CV joint.

Measurement Guide  #4 & #5  - Van and Pick-Up truck applications with hanger bearing.

Measurement Guide  #6 & #7  - Yoke and U-Joint.

Measurement Guide  #8 & #9  - Van, Pickup and Heavy Duty applications with and without hanger bearing.